Hey, I need the following design:
General Overview: Bumper + Back plate
the bumper will stay at the phone (iPhone X). The back plate needs to be detachable (several times a day).
Possible are magnets or a 'klick' mechanism or another creative solution.
a) Back plate
The back plate is 2mm strong. The 4 points of the mechanism need to be at the shown position. Also, it should be possible to use them as legs.
b) Bumper
The bumper stays at the phone. It should not damage the phone. A combination of silicon and plastic would be preferred. It will be an SLA Thermoplast print.
Summary:
- We need the 3d files of the bumper the backplate and the mechanism for an iPhone X.
- The 3D files need to be printed and tested by the designer.
- A short clip of the printed design + mechanism has to be supplied
Please start the message with 'Hi Philip', so I know you have read the description. Also, please keep in mind, that this task will be done for more models, if you manage iPhone X.
About the recuiterMember since May 20, 2018 Resume Admin
from Sokoto, Nigeria