Remote Architecture Job In Engineering And Architecture

PCB Layout Designing

Find more Architecture remote jobs posted recently Worldwide

I want to develop a PCB Layout Design for a given Circuit Diagram.

I want a 2 layer PCB layout design.

The PCB design should be done using ORCAD 9 or, 16.0.
About the recuiter
Member since Nov 11, 2022
Hemant Agarwal
from Queensland, Australia

Skills & Expertise Required

OrCAD PCB Design 

Open for hiringApply before - Oct 2, 2024

Work from Anywhere

40 hrs / week

Fixed Type

Remote Job

$47.89

Cost

Offer to work on this project closes in 139 days!
Are you interested in this Opportunity?

Looking for help? Checkout our video tutorial
How to search and apply for jobs

How to apply? Do you have more questions about the Job?
See frequently asked questions

Similar Projects

Arduino wiz needed for project layout

Need an arduino circuit layout made based off of the parts that we currently have. Deliverable is going to look like a circuit layout with the following:

1. SD Card module used for either .mp3 or .wav files to be played.
2. PAM3804 3 x 2...read more

Need Electronics Engineer to design a circuit and parts list for a battery charge controller MVP

Im looking for an electronics engineer who can help in designing a circuit and parts list for me for a battery charger/conditioner.

MVP Requirements:

The charge controller needs to run a sequence when a battery is connected. This s...read more

Altium PCB layout

Requires PCB layout of two small circuit cards using the Altium CAD tool. The circuitry is quite dense and includes bus lines operating up to 200 Mhz. One circuit card includes 2 wifi modules with connections from the module to antennas for 2.4 and 5...read more

Looking for an electrical engineer

The job is replacing a fuse inside a control box of a prototype of a coffee machine. The machine has been put on 220v while it could only bear 110v. Now the fuse needs to be checked and replaced. You need to be in Los Angeles, Santa Monica or Venice....read more

PCB design and component build for an FX Pedal/Box

I need an FX Pedal/Box designed and built that plugs into the mains and takes a quarter inch jack for both the IN and OUT signal ports. The effects needed are tape delay, reverb and echo. Each effect requires a volume slide, oscillator, a feedback di...read more