Need Electronics Engineer to design a circuit and parts list for a battery charge controller MVP

Im looking for an electronics engineer who can help in designing a circuit and parts list for me for a battery charger/conditioner.

MVP Requirements:

The charge controller needs to run a sequence when a battery is connected. This sequence should look as follows:

- Cycle discharge->charge battery (Bonus: be able to choose # of cycles)
- Record discharge capacity, compare against nominal/rated capacity
- If discharge capacity is 80% or more than nominal capacity
- Then cycle discharge->charge battery 2 more times for good measure
- Record last discharge capacity

- Else put 15A input current on battery (1 sec duration, 5x times)
- Cycle battery another 3 times
- Check if capacity has increased (80% or more of nominal), if not repeat 15A load another 3 times
- Display/log last discharge capacity

In short:
- Cycle the battery
- Zap it with high current a few times if bad
- Cycle again
- Display status/results on an OLED display

Bonus/Future Improvements:
- Connect via USB and log data to file
- Automatically determine nominal voltage of connected battery cell/pack
- Temperature check to avoid battery cell overheating


My budget for parts is $100 for the initial MVP. Just looking to get it to work at this point.
About the recuiter
Member since Aug 30, 2017
Adam S.
from Maryland, United States

---

---

Offer to work on this project closes in 112 days!
Are you interested in this Opportunity?

Looking for help? Checkout our video tutorial
How to search and apply for jobs

How to apply? Do you have more questions about the Job?
See frequently asked questions