Remote Architecture Job In Engineering And Architecture

Alarming Device when in Low temp Liquid Contact for level monitoring

Find more Architecture remote jobs posted recently Worldwide

I have a Tank that I fill with Liquid Nitrogen (-196 C) I want to have a Probe that I can stick down in the tank and trigger a normally open NO/normally closed NC alarms at different depths in the tank.

It has to run on a battery and last longer that 1 year (standard battery preferred)
Essentially when the liquid nitrogen drops a the top of the tank one alarm should be triggered and remain triggered until the liquid is filled. But the liquid can drop further down and hit the next alarm point and then trigger again.

All the wires/electronics can be routed to the outside of the tank with only the either RTD or other sensor exposed to the -196 C


Potentially I would want to have this project grow to connect to 4G network and text/call/email me when alarms occur also store data potentially too, but first this Probe/sensor level should be tested by me. thanks
About the recuiter
Member since Nov 11, 2022
Rory Millikin
from Cagayan Valley, Philippines

Open for hiringApply before - May 21, 2024

Work from Anywhere

40 hrs / week

Hourly Type

Remote Job

$24.95

Cost

Offer to work on this project closes in 2 days!
Are you interested in this Opportunity?

Looking for help? Checkout our video tutorial
How to search and apply for jobs

How to apply? Do you have more questions about the Job?
See frequently asked questions

Similar Projects

Structural engineer to help me build plans so I can submit them via permit office.

Stamped, concrete plans to submit

I would much prefer someone who lives in Las Vegas where I am located so they can look at my project and we can make a plan (no pun intended).

Need Parts list and Arduio Sketch for Stepper Motor

Hello, I am trying to use an arduino to program a motor to control a lead screw to move a 140ml syringe to release fluid at a rate of 10ml per minute out of a 32ga needle.

I need the motor to have quite a bit of torque since we are pushing...read more